2024 Generac Power Systems Bi-Fuel Industrial Generators SB600

Information

2024 Generac Power Systems Bi-Fuel Industrial Generators SB600

Generator Paralleling

Generac's Modular Power Systems (MPS) boast a rate of up to 99.999% reliability, and are more cost-effective and flexible than single generators with the same load capacity. Generac BI-FUEL™ generators meet the on-site fuel requirements for emergency systems as referenced in NEC700 and NFPA 110, and they have the only EPA compliant engine right from the factory. Since less diesel is used, they have fewer emissions and a smaller carbon footprint compared to diesel only.

Features may include:

Generator EnclosureGenerator EnclosureGenerac Bi-Fuel™ Engine
  • Generac's BI-FUEL™ generators are fully integrated solutions, not after-market conversions in the field.
Industrial Alternator
  • Generac industrial alternators are machine wound, machine inserted, and machine varnished for the ultimate in consistency.
Powermanager Controller
  • Generac engineers its generator controls with safety and convenience as top priorities.

Photos

Highlights

  • Fort Wayne, Indiana
  • 2024
  • Generac Power Systems
  • Bi-Fuel Industrial Generators SB600
  • Piston Type: Aluminum | Crankshaft Type: I-Beam Section
  • Ultra Low Sulfur Diesel #2
  • Available

Specifications

  • 2024
  • Generac Power Systems
  • Bi-Fuel Industrial Generators
  • SB600
  • General
  • Piston Type: Aluminum | Crankshaft Type: I-Beam Section
  • Perkins
  • EPA Emissions Compliance: Stationary Emergency | EPA Emissions Reference: See Emission Data Sheet
  • 6 | Cylinder Head: 4-Valve
  • In-Line | Intake Air Method: Turbocharged/Aftercooled
  • 1,106.36 in3 (18.13 L)
  • 5.71 in (145 mm)
  • 7.20 in (183 mm)
  • 14.5:1
  • Oil Pump Type: Gear | Oil Filter Type: Full Flow
  • Type: Closed Recovery | Fan Type: Pusher | Water Pump Type: Centrifugal Type, Belt-Driven
  • Specifications: ASTM | Filtering (Microns): Primary 10 - Secondary 2 | Engine Type: Pre-Combustion
  • Ultra Low Sulfur Diesel #2
  • Pump Make: Electronic | Type: MEUI
  • Electronic Isochronous | Frequency Regulation (Steady State): ±0.25%
  • Size: See Battery Index 0161970SBY | Voltage: (2) - 12 VDC | Ground Polarity: Negative
  • Alternator: 70 Amps
  • System Voltage: 24 VDC
  • Model: K0792124Y23 | Poles: 4 | Field Type: Revolving | Insulation Class - Rotor: H | Insulation Class - Stator: H | Total Harmonic Distortion: <3% | Telephone Interference Factor (TIF): < 50 | Standard Excitation: Permanent Magnet | Bearings: Single Sealed Cartridge | Coupling: Direct via Flexible Disc | Voltage Regulator Type: Full Digital | Regulation Accuracy (Steady State): ±0.25%
  • Cooling: 1,658 RPM
  • Maximum Required Volume of Natural Gas Needed: 50 scfm (15 m3 /min)
  • Required Natural Gas Pressure: 1 psi (7 kPa)
  • Fuel Supply Line: 0.5 in (12.7 mm) NPT | Fuel Return Line: 0.5 in (12.7 mm) NPT
  • 38 in (965 mm)
  • Crankcase Capacity: 47.55 qt (45 L)